Sinoboom hydraulic motor scissor lift errors
Share
Technical Diagnostic Guide for Sinoboom Scissor Lifts with Hydraulic Motor
Introduction: Preventive maintenance and technical responsiveness are the pillars of an efficient rental fleet. For Sinoboom hydraulic scissor lifts, understanding the diagnostic system is key to minimizing downtime.
It is crucial to remember that after powering on, you must wait 3 seconds to allow the machine to complete its initial check before performing any operation. In this article, we detail error codes, function limitations, and practical solutions directly extracted from the Sinoboom technical training manual.
Are you having problems with an electric scissor lift? Consult our Sinoboom error guide here.
1. Error Codes and System Limitations
| Code | Error Description | Limiting Action | Solution and Guide Search |
|---|---|---|---|
| 01 | System initialization error | All functions | Possible ECU failure; replace ECU. |
| 02 | System communication error | All functions | Check chassis controller, joystick, or connection cable. |
| 03 | Incorrect configuration error | All functions | Configure correct parameters. |
| 12 | Chassis switch activated before check | Limits chassis actions | Verify if switch is stuck or if controller is defective. |
| 18 | Pothole protection error | Limits lift and drive | Check if skirts are obstructed or if microswitches are damaged. |
| 31 | Pressure sensor error | All functions | Verify sensor power; replace if no output signal. |
| 32 | Angle sensor error | All functions | Check sensor input/output and selected machine mode. |
| 42/43 | Direction button (Left/Right) pressed before check | Error on screen only | Reset and wait 3s without touching anything; evaluate joystick or ECU replacement. |
| 46 | Man present button pressed before check | Limits functions from basket | Reset and wait 3s; consider joystick or ECU replacement. |
| 47 | Joystick out of neutral position | Reduced lift speed | Verify zero parameters with LabView; possible joystick or ECU replacement. |
| 52-57 | Solenoid valve error (Drive, Lift, Lower, Steering) | Limits lift and drive | Check wiring, connector, and measure coil resistance (Ohm). |
| 68 | Low voltage error | All functions | Check battery voltage, charge, and inspect connections. |
| OL | Platform overloaded | All functions | Remove weight from basket; verify or recalibrate pressure sensor. |
| LL | Machine out of tilt | Limits lift and drive | Return to horizontal level; check inclinometer wiring. |
2. Common Troubleshooting
In addition to specific codes, the manual identifies recurring faults and their probable causes:
- Error 02 in basket (communication): Usually due to a poor connection between the chassis and the basket, damaged cables in the pantograph, or incorrect controller configuration.
- Error 18 (Pothole): Poor contact or damage to the "Down Limit Switch" or the pothole microswitches.
- LL level alarm (when on flat ground): Check if the inclinometer is loose or if the "zero" value is incorrect; requires recalibration.
- Screen off in basket or chassis: Verify that the key is not in OFF, that emergency stop buttons are not pressed, or check fuses.
- Machine stops intermittently: May be due to insufficient voltage or a miscalibrated inclinometer.
Important Notes
- Always wait 3 seconds after powering on before operating the machine.
- For any persistent error code, consult the Sinoboom technical manual.
- Keeping a record of errors facilitates preventive maintenance and fleet management.